The emergence of furniture manufacturers in _ furniture plate splicing problems and Solutions
One is that after the furniture plate is spliced, the adhesive tape is not firmly fastened, which leads to a lack of firmness. This is because the tape is not fully wet, sewing machine heating roller temperature is too high or too low on the roll pressure is not enough. The method and the method are simple, and the adhesive tape can be fully moistened with water; the heating roller is checked; and the pressing force of the upper rolling rod is increased.
The second is that the seam is too tight or loose situation, the main problem is the feed sewing machine squeezing roller adjustment caused by the inappropriate. Board furniture manufacturers said that to meet such a situation as long as we adjust to a taper work sewing machine under the table squeezing roller, which can be suitable.
It is pointed out that the single board furniture manufacturers Banduan head third is often spelled out is not homogeneous, this situation is mainly caused by improper operation in the longitudinal seam, with gluing machine feeding when the single head is not aligned on both sides of Banduan or single board edge is caused by rectangular. In this case, it is necessary to know that there should be a benchmark for the edges of a single plate and that a single plate should not be cut into a parallelogram.